The new KORDZ® CAT-HD40 is a fantastic and innovative new product which enables the passing of a full HDMI bitstream over a parallel pair of CAT5E or CAT6 cables. Simply run two lengths of CAT5E or preferably CAT6 and terminate at both ends with RJ45 connectors. Connect a fully approved HDMI cable (1.3 spec preferred) from source to the HDMI input of the “Sender” unit, twin CAT cables from “Sender” to “Receiver”, then another short length approved HDMI cable from “Receiver” unit to the sink/display. The results are astonishing, broadly equivalent to the KORDZ® Evolution series UP-OFC HDMI 1.2a cable series.
When should I use the CAT-HD40? Use for installations where 1080p is required over longer lengths that cannot be supported by a pasive HDMI cable. However where full resolution support is attainable from a passive cable (such as KORDZ EVO or EVS series up to 10m, or MASTER™ series HDMI 1.3 to 15m, the passive cable is still the preferred option. Also handy for conduit installations, where an installed HDMI cable has been damaged or is redundant, or where cable length needs to be variable.
The CAT-HD40 is supplied as a send (TX) and receive (RX) pair, complete with 5V DC power supply (which connects to the sink/display side unit). Resolution support up to 25m for full 1080p over CAT5E UTP, or up to 60m for 720p/1080i. The use of CAT6 UTP can extend performance to a huge 40m with full 1080p 60Hz, depending on source and display capabilities and nativity of 1080p source (ie distance from upscaled sources may vary).
 Plug 'n' play operation uses standard ethernet RJ45 configuration, STP or UTP cable
Sender unit does not require external power, receive unit (TV end) requires 5V DC power (included)
24k gold plated HDMI receptacles
Superior build quality, full metal housing with painted black finish
Full kit includes sender unit, receiver unit and DC power pack
12 MONTH WARRANTY |
